ShopDreamUp AI ArtDreamUp
Deviation Actions
Suggested Deviants
Suggested Collections
You Might Like…
Featured in Groups
Description
Upper picture: Vambrace 2.0, it's bigger than the last one and therefor fits the refs a lot better. Still having the unfinished hidden blade as mock up (I'll probably keep the tip, ditching the handle.
Lower left: Early hood construction. Later I got rid of some fabric on the inside and cut some corners off to make the points pointier and the inside blue lining go back again (it sticks out at the front).
Lower right: some gear put on, the cuff is now attached to the sleeves.
Btw, allthough I needed to heavily modify this (switch some stitching lines and adding 5 cm underneath) I still think I'm ought to credit ~Franky-bizarro for his amazing hood pattern, located at:
[link]
Lower left: Early hood construction. Later I got rid of some fabric on the inside and cut some corners off to make the points pointier and the inside blue lining go back again (it sticks out at the front).
Lower right: some gear put on, the cuff is now attached to the sleeves.
Btw, allthough I needed to heavily modify this (switch some stitching lines and adding 5 cm underneath) I still think I'm ought to credit ~Franky-bizarro for his amazing hood pattern, located at:
[link]
Image size
2124x1398px 3.19 MB
© 2012 - 2024 Trujin
Comments66
Join the community to add your comment. Already a deviant? Log In
Hey just had a question about the hood. How did you size it? The pattern in the link is clearly smaller than it needs to be, so did you draw it out by hand and increase the size, or did you just print it multiple times at different magnifications until you had the right size? If so, by what percentage did you increase the pattern size?